Re: [PATCH] clocksource/drivers/tegra: rework for compensation of suspend time

From: Joseph Lo
Date: Tue Apr 02 2019 - 11:50:29 EST


On 4/2/19 10:46 PM, Thierry Reding wrote:
On Tue, Apr 02, 2019 at 11:02:34AM +0800, Joseph Lo wrote:
Since the clocksource framework has the support for suspend time
compensation. Re-work the driver to use that, so we can reduce the
duplicate code.

Suggested-by: Daniel Lezcano <daniel.lezcano@xxxxxxxxxx>
Signed-off-by: Joseph Lo <josephl@xxxxxxxxxx>
---
drivers/clocksource/timer-tegra20.c | 63 +++++++++--------------------
1 file changed, 20 insertions(+), 43 deletions(-)

Nice!


diff --git a/drivers/clocksource/timer-tegra20.c b/drivers/clocksource/timer-tegra20.c
index fdb3d795a409..919b3568c495 100644
--- a/drivers/clocksource/timer-tegra20.c
+++ b/drivers/clocksource/timer-tegra20.c
@@ -60,9 +60,6 @@
static u32 usec_config;
static void __iomem *timer_reg_base;
#ifdef CONFIG_ARM
-static void __iomem *rtc_base;
-static struct timespec64 persistent_ts;
-static u64 persistent_ms, last_persistent_ms;
static struct delay_timer tegra_delay_timer;
#endif
@@ -199,40 +196,30 @@ static unsigned long tegra_delay_timer_read_counter_long(void)
return readl(timer_reg_base + TIMERUS_CNTR_1US);
}
+static struct timer_of suspend_rtc_to = {
+ .flags = TIMER_OF_BASE | TIMER_OF_CLOCK,
+};
+
/*
* tegra_rtc_read - Reads the Tegra RTC registers
* Care must be taken that this funciton is not called while the
* tegra_rtc driver could be executing to avoid race conditions
* on the RTC shadow register
*/
-static u64 tegra_rtc_read_ms(void)
+static u64 tegra_rtc_read_ms(struct clocksource *cs)
{
- u32 ms = readl(rtc_base + RTC_MILLISECONDS);
- u32 s = readl(rtc_base + RTC_SHADOW_SECONDS);
+ u32 ms = readl(timer_of_base(&suspend_rtc_to) + RTC_MILLISECONDS);
+ u32 s = readl(timer_of_base(&suspend_rtc_to) + RTC_SHADOW_SECONDS);
return (u64)s * MSEC_PER_SEC + ms;
}
-/*
- * tegra_read_persistent_clock64 - Return time from a persistent clock.
- *
- * Reads the time from a source which isn't disabled during PM, the
- * 32k sync timer. Convert the cycles elapsed since last read into
- * nsecs and adds to a monotonically increasing timespec64.
- * Care must be taken that this funciton is not called while the
- * tegra_rtc driver could be executing to avoid race conditions
- * on the RTC shadow register
- */
-static void tegra_read_persistent_clock64(struct timespec64 *ts)
-{
- u64 delta;
-
- last_persistent_ms = persistent_ms;
- persistent_ms = tegra_rtc_read_ms();
- delta = persistent_ms - last_persistent_ms;
-
- timespec64_add_ns(&persistent_ts, delta * NSEC_PER_MSEC);
- *ts = persistent_ts;
-}
+static struct clocksource suspend_rtc_clocksource = {
+ .name = "tegra_suspend_timer",
+ .rating = 200,
+ .read = tegra_rtc_read_ms,
+ .mask = CLOCKSOURCE_MASK(32),
+ .flags = CLOCK_SOURCE_IS_CONTINUOUS | CLOCK_SOURCE_SUSPEND_NONSTOP,
+};
#endif
static int tegra_timer_common_init(struct device_node *np, struct timer_of *to)
@@ -385,25 +372,15 @@ static int __init tegra_init_timer(struct device_node *np)
static int __init tegra20_init_rtc(struct device_node *np)
{
- struct clk *clk;
+ int ret;
- rtc_base = of_iomap(np, 0);
- if (!rtc_base) {
- pr_err("Can't map RTC registers\n");
- return -ENXIO;
- }
+ ret = timer_of_init(np, &suspend_rtc_to);
+ if (ret)
+ return ret;
- /*
- * rtc registers are used by read_persistent_clock, keep the rtc clock
- * enabled
- */
- clk = of_clk_get(np, 0);
- if (IS_ERR(clk))
- pr_warn("Unable to get rtc-tegra clock\n");
- else
- clk_prepare_enable(clk);
+ clocksource_register_hz(&suspend_rtc_clocksource, 1000);
- return register_persistent_clock(tegra_read_persistent_clock64);
+ return 0;
}
TIMER_OF_DECLARE(tegra20_rtc, "nvidia,tegra20-rtc", tegra20_init_rtc);
#endif

I wonder if there's any reason left for the #ifdefs now. My recollection
is that these were only needed because register_persistent_clock() was
not available on 64-bit ARM. The new APIs seem to be available
regardless of architecture, so do we still need to differentiate?


Actually, only Tegra20/30 that doesn't have ARM arch timer support need this. The latter Tegra chips which have ARM arch timer support use TSC ( time stamp counter or timer system counter depends on the chip it has different name) as the timer source in the PMC. And it uses OSC during runtime and switches to 32KHz always-on clock source to keep counting when the chip is in the SC7 or LP0 state.

So I didn't change that for this reason.

Thanks,
Joseph