Re: [PATCH net-next v4 1/2] net: phy: marvell10g: implement suspend/resume callbacks

[Russell King - ARM Linux admin]

On Tue, Apr 02, 2019 at 08:17:16PM +0200, Heiner Kallweit wrote:
> On 02.04.2019 15:10, Antoine Tenart wrote:
> > This patch adds the suspend/resume callbacks for Marvell 10G PHYs. The
> > three PCS (base-t, base-r and 1000base-x) are set in low power (the PCS
> > are powered down) when the PHY isn't used.
> > 
> > Signed-off-by: Antoine Tenart <antoine.tenart@xxxxxxxxxxx>
> > ---
> >  drivers/net/phy/marvell10g.c | 12 +++++++++++-
> >  1 file changed, 11 insertions(+), 1 deletion(-)
> > 
> > diff --git a/drivers/net/phy/marvell10g.c b/drivers/net/phy/marvell10g.c
> > index 80678919641d..9ee033c8a12b 100644
> > --- a/drivers/net/phy/marvell10g.c
> > +++ b/drivers/net/phy/marvell10g.c
> > @@ -51,6 +51,8 @@ enum {
> >  	MV_AN_STAT1000		= 0x8001, /* 1000base-T status register */
> >  
> >  	/* Vendor2 MMD registers */
> > +	MV_V2_PORT_CTRL		= 0xf001,
> > +	MV_V2_PORT_CTRL_PWRDOWN = 0x0800,
> 
> If this driver is touched again I think it would be good to change all
> such constants to BIT() and GENMASK(), ideally combined with the macros
> from bitfields.h. This makes it much easier to check the code against the
> datasheet. Apart from that:

Specifically, which constants are you talking about?

I think there's only MV_PCS_PAIRSWAP_MASK and MV_V2_TEMP_CTRL_MASK,
which would be confusing to change given that the following definitions
are values for the masked field.

However, MV_V2_PORT_CTRL_PWRDOWN should be defined using BIT() in any
case.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up
According to speedtest.net: 11.9Mbps down 500kbps up