Re: [PATCH v2] usb: typec: tcpm: collision avoidance

[Heikki Krogerus]

Hi,

On Fri, Mar 22, 2019 at 08:17:45PM +0800, Kyle Tso wrote:
> This patch provides the implementation of Collision Avoidance introduced
> in PD3.0. The start of each Atomic Message Sequence (AMS) initiated by
> the port will be denied if the current AMS is not interruptible. The
> Source port will set the CC to SinkTxNG if it is going to initiate an
> AMS, and SinkTxOk otherwise. Meanwhile, any AMS initiated by a Sink port
> will be denied in TCPM if the port partner (Source) sets SinkTxNG except
> for HARD_RESET and SOFT_RESET.

I tested this with my GDBWin which has fusb302. When I plug-in
DisplayPort adapter, the partner device never gets registered, and I
see steady flow of warnings from fusb302:

[  693.391176] Vconn is on during toggle start
[  693.391250] WARNING: CPU: 2 PID: 30 at drivers/usb/typec/tcpm/fusb302.c:562 fusb302_set_toggling+0x129/0x130 [fusb302]
[  693.400293] Modules linked in: intel_xhci_usb_role_switch fusb302 tcpm roles pi3usb30532 i915 typec intel_gtt intel_cht_int33fe
[  693.406309] CPU: 2 PID: 30 Comm: kworker/u8:1 Tainted: G        W         5.1.0-rc3-heikki+ #17
[  693.408434] cht_wcove_pwrsrc cht_wcove_pwrsrc: Could not detect charger type
[  693.412278] Hardware name: Default string Default string/Default string, BIOS 5.11 05/25/2017
[  693.412283] Workqueue: i2c-fusb302 tcpm_state_machine_work [tcpm]
[  693.424256] RIP: 0010:fusb302_set_toggling+0x129/0x130 [fusb302]
[  693.427234] Code: 89 df e8 da ef ff ff 85 c0 78 c6 c6 83 b0 01 00 00 00 eb b7 b9 02 00 00 00 e9 48 ff ff ff 48 c7 c7 20 e8 21 a0 e8 8e 0c e4 e0 <0f> 0b e9 58 ff ff ff 41 55 4c 8d 6f e8 41 54 41 89 f4 55 53 48 8d
[  693.436204] RSP: 0000:ffffc9000076bd90 EFLAGS: 00010286
[  693.439174] RAX: 0000000000000000 RBX: ffff888178080028 RCX: 0000000000000000
[  693.442157] RDX: 000000000000001f RSI: ffffffff8259051f RDI: ffffffff8259091f
[  693.445130] RBP: 0000000000000003 R08: ffffffff82590500 R09: 00000000000202c0
[  693.448100] R10: 0000010cb24a3d18 R11: 000000000000001e R12: ffff8881780801b0
[  693.451086] R13: ffffffffa021e4e5 R14: 0000000000000003 R15: ffff888178080040
[  693.454060] FS:  0000000000000000(0000) GS:ffff88817bb00000(0000) knlGS:0000000000000000
[  693.460009] CS:  0010 DS: 0000 ES: 0000 CR0: 0000000080050033
[  693.462984] CR2: 00000000f7fb74a0 CR3: 000000000200d000 CR4: 00000000001006e0
[  693.465969] Call Trace:
[  693.468937]  tcpm_set_cc+0xb9/0x170 [fusb302]
[  693.471894]  tcpm_ams_start+0x1b8/0x2a0 [tcpm]
[  693.474855]  ? _cond_resched+0x10/0x20
[  693.477807]  tcpm_state_machine_work+0x57e/0x28f6 [tcpm]
[  693.480776]  ? tcpm_pd_event_handler+0x111/0x320 [tcpm]
[  693.483743]  process_one_work+0x1da/0x410
[  693.486703]  worker_thread+0x28/0x3c0
[  693.489651]  ? process_one_work+0x410/0x410
[  693.492603]  kthread+0x10b/0x130
[  693.495548]  ? kthread_create_on_node+0x60/0x60
[  693.498506]  ret_from_fork+0x1f/0x30


Here's the tcpm debugfs log:

[  692.553000] CC1: 0 -> 2, CC2: 0 -> 1 [state DRP_TOGGLING, polarity 0, connected]
[  692.553016] state change DRP_TOGGLING -> SRC_ATTACH_WAIT
[  692.553056] pending state change SRC_ATTACH_WAIT -> SNK_TRY @ 200 ms
[  692.757402] state change SRC_ATTACH_WAIT -> SNK_TRY [delayed 200 ms]
[  692.757410] cc:=2
[  692.761946] pending state change SNK_TRY -> SNK_TRY_WAIT @ 100 ms
[  692.869308] state change SNK_TRY -> SNK_TRY_WAIT [delayed 100 ms]
[  692.869313] state change SNK_TRY_WAIT -> SRC_TRYWAIT
[  692.869317] cc:=3
[  692.873657] pending state change SRC_TRYWAIT -> SRC_TRYWAIT_UNATTACHED @ 100 ms
[  692.882524] CC1: 2 -> 2, CC2: 1 -> 1 [state SRC_TRYWAIT, polarity 0, connected]
[  692.882537] state change SRC_TRYWAIT -> SRC_TRYWAIT_DEBOUNCE
[  692.882567] pending state change SRC_TRYWAIT_DEBOUNCE -> SRC_ATTACHED @ 200 ms
[  693.085337] state change SRC_TRYWAIT_DEBOUNCE -> SRC_ATTACHED [delayed 200 ms]
[  693.085347] polarity 0
[  693.085352] Requesting mux state 1, usb-role 1, orientation 1
[  693.346845] vconn:=1
[  693.347174] vbus:=1 charge=0
[  693.358340] pending state change SRC_ATTACHED -> SRC_UNATTACHED @ 480 ms
[  693.378702] VBUS on
[  693.378711] state change SRC_ATTACHED -> SRC_STARTUP
[  693.378741] AMS POWER_NEGOTIATION start
[  693.378745] cc:=4
[  693.505321] state change SRC_STARTUP -> AMS_START in AMS POWER_NEGOTIATION
[  693.505325] state change AMS_START -> SRC_SEND_CAPABILITIES in AMS POWER_NEGOTIATION
[  693.505327] PD TX, header: 0x11a1
[  693.613296] pending state change SRC_SEND_CAPABILITIES -> SRC_SEND_CAPABILITIES @ 150 ms in AMS POWER_NEGOTIATION
[  693.613309] CC1: 2 -> 2, CC2: 1 -> 1 [state SRC_SEND_CAPABILITIES, polarity 0, connected]
[  693.765730] state change SRC_SEND_CAPABILITIES -> SRC_SEND_CAPABILITIES [delayed 150 ms]
[  693.765753] PD TX, header: 0x11a1
[  693.770016] PD TX complete, status: 0
[  693.770261] pending state change SRC_SEND_CAPABILITIES -> SRC_SEND_CAPABILITIES_TIMEOUT @ 150 ms in AMS POWER_NEGOTIATION
[  693.775178] PD RX, header: 0x1042 [1]
[  693.775195] state change SRC_SEND_CAPABILITIES -> SRC_NEGOTIATE_CAPABILITIES
[  693.775236] Requested 5000 mV, 400 mA for 400 / 900 mA
[  693.775244] PD TX, header: 0x363
[  693.778253] PD TX complete, status: 0
[  693.778363] pending state change SRC_NEGOTIATE_CAPABILITIES -> SRC_TRANSITION_SUPPLY @ 35 ms
[  693.803463] Received hard reset
[  693.803473] state change SRC_NEGOTIATE_CAPABILITIES -> HARD_RESET_START
[  693.806323] pending state change HARD_RESET_START -> SRC_HARD_RESET_VBUS_OFF @ 30 ms
[  693.837400] state change HARD_RESET_START -> SRC_HARD_RESET_VBUS_OFF [delayed 30 ms]
[  693.837414] vconn:=1
[  693.837426] vbus:=0 charge=0
[  693.843380] Requesting mux state 1, usb-role 1, orientation 1
[  693.844554] pending state change SRC_HARD_RESET_VBUS_OFF -> SRC_HARD_RESET_VBUS_ON @ 760 ms
[  693.844575] VBUS off
[  693.844580] state change SRC_HARD_RESET_VBUS_OFF -> SRC_HARD_RESET_VBUS_ON
[  693.844617] vbus:=1 charge=0
[  693.850688] pending state change SRC_HARD_RESET_VBUS_ON -> SRC_UNATTACHED @ 480 ms
[  693.868706] VBUS on
[  693.868713] state change SRC_HARD_RESET_VBUS_ON -> SRC_STARTUP
[  693.868742] AMS POWER_NEGOTIATION start
[  693.868749] cc:=4
[  694.101422] state change SRC_STARTUP -> AMS_START in AMS POWER_NEGOTIATION
[  694.101425] state change AMS_START -> SRC_SEND_CAPABILITIES in AMS POWER_NEGOTIATION
[  694.101428] PD TX, header: 0x11a1
[  694.205301] pending state change SRC_SEND_CAPABILITIES -> SRC_SEND_CAPABILITIES @ 150 ms in AMS POWER_NEGOTIATION
[  694.205317] CC1: 2 -> 2, CC2: 1 -> 1 [state SRC_SEND_CAPABILITIES, polarity 0, connected]
[  694.325808] Received hard reset
[  694.325816] state change SRC_SEND_CAPABILITIES -> HARD_RESET_START in AMS NONE_AMS
[  694.329208] pending state change HARD_RESET_START -> SRC_HARD_RESET_VBUS_OFF @ 30 ms in AMS NONE_AMS
[  694.359394] state change HARD_RESET_START -> SRC_HARD_RESET_VBUS_OFF [delayed 30 ms]
[  694.359401] vconn:=1
[  694.359408] vbus:=0 charge=0
[  694.366321] Requesting mux state 1, usb-role 1, orientation 1
[  694.367685] pending state change SRC_HARD_RESET_VBUS_OFF -> SRC_HARD_RESET_VBUS_ON @ 760 ms in AMS NONE_AMS
[  694.367700] VBUS off
[  694.367704] state change SRC_HARD_RESET_VBUS_OFF -> SRC_HARD_RESET_VBUS_ON in AMS NONE_AMS
[  694.367721] vbus:=1 charge=0
[  694.374175] pending state change SRC_HARD_RESET_VBUS_ON -> SRC_UNATTACHED @ 480 ms in AMS NONE_AMS
[  694.374194] CC1: 2 -> 0, CC2: 1 -> 0 [state SRC_HARD_RESET_VBUS_ON, polarity 0, disconnected]
[  694.374201] state change SRC_HARD_RESET_VBUS_ON -> SRC_UNATTACHED in AMS NONE_AMS
[  694.631957] Start DRP toggling


thanks,

-- 
heikki