Re: [PATCH v2 5/5] ARM: dts: sun50i: h6: Introduce Beelink GS1 board

[ClÃment PÃron]

Hi,

On Fri, 5 Apr 2019 at 17:11, Maxime Ripard <maxime.ripard@xxxxxxxxxxx> wrote:
>
> On Fri, Apr 05, 2019 at 02:53:35PM +0200, ClÃment PÃron wrote:
> > Hi,
> >
> > Adding this r_pio regulators make a new error in the bootlog :
> >
> > [    0.346843] sun50i-h6-r-pinctrl 7022000.pinctrl: Couldn't get bank
> > PL regulator
> > [    0.346853] sun50i-h6-r-pinctrl 7022000.pinctrl: request() failed for pin 352
> > [    0.346862] sun50i-h6-r-pinctrl 7022000.pinctrl: pin-352
> > (7081400.i2c) status -517
> > [    0.346871] sun50i-h6-r-pinctrl 7022000.pinctrl: could not request
> > pin 352 (PL0) from group PL0  on device 7022000.pinctrl
> > [    0.346878] mv64xxx_i2c 7081400.i2c: Error applying setting,
> > reverse things back
> >
> > PL0 and PL1 are SCK/SDA for the PMIC :(
>
> How was this DT tested then?

There was a mistake when I tested the patch v2 and only saw this after
posting the patch.

Can I submit a V3 without pio / r_pio regulators ? (+ the yaml patch separated)

Thanks,

>
> Maxime
>
> --
> Maxime Ripard, Bootlin
> Embedded Linux and Kernel engineering
> https://bootlin.com